User Manual

42 / 90
3 Configuration of the WIMAN radio modem
Information:
The following instruction can be issued likewise from all
higher authorization levels.
2. Change from the command mode of authorization level one
(indicated by the character " > " at the end of the command
line prompt) into the configuration mode by input of the
command config.
The command prompt of the configuration-mode appears:
WIMAN-II (config) >
3. Type in the command del passwd console and press
ENTER.
The former password is now deleted in the new configura-
tion.
4. Leave the configuration mode by entering the command
exit (see page 17).
5. Proceed as shown in chapter 3.4.1 on page 36.
3.5.3 Setting of a Password for Authorization Level two
(Enable)
A password for authorization level two is always required.
However, it can be changed to suit the requirements of the Pro-
vider.
To change the password for authorization level two proceed as
follows:
1. Access the command line prompt of authorization level
two:
a) Access authorization level one (See chapter 3.5.1on
page 40)
b) Enter the command enable.
As a password is always required, you need to enter
the correct password
Enter password: ****
Type in the correct password (pay attention to upper-
and lowercase characters) and press ENTER.
c) The command line prompt appears, e.g.:
WIMAN-II #
Proceed with No. 2.
Direct entrance over the password-protected com-
mand line level of authorization levels one and two: