User Manual
50 / 90
4 Hardware Installation
2. Double-check the solder joints and the pin-allocation inside
the plugs of the data cable.
3. Check the hybrid cables by alternating them one at a time.
4.2 Installation of a WIMAN Star
4.2.1 Additional necessary components
Checklist:
In addition to the parts specified in Chapter 4.1.2, page 45, the
following components are needed for the installation of a
WIMAN STAR:
• Tower standoffs
• 1 WIMAN Access with Indoor-Set for testing purposes
• 1 Router for testing
• Configuration files for all radio modems
4.2.2 Preparation
To install a WIMAN star:
1. Label all WIMAN units according to the convention:
XX-YYY-ZZZ.
• XX = LM (Line Master), LS (Line Slave), SM (Star Multi-
point), AS (Access)
• YYY= NetId (0-255)
• ZZZ = adjustment of the antenna (0 -359°) – towards north.
2. Install the WIMAN radio modem and Typ-3-Hybrid cable
in the outdoor housings.
3. Label the remaining WIMAN utensils according to the
convention indicated above. You should label: