User Manual

40 / 90
3 Configuration of the WIMAN radio modem
To setup the network parameter:
Attention:
In order to avoid disturbances of the current line operation, only
qualified personnel in arrangement with the Provider may exe-
cute these adjustments.
Checklist:
You need a list of the parameters that can be configured of your
Provider.
Proceed as shown in Chapter 3.4.1 on page 36
3.4.4 Setup of the other parameters
The only other parameters are PS1 and SyncMode (see page 25).
Note:
In order to avoid disturbances of the current line operation, only
qualified personnel in arrangement with the Provider may exe-
cute these adjustments.
Proceed as shown in Chapter 3.4.1 on page 36
3.5 Modification of the WIMAN Passwords
This section deals with the configuration of the passwords of the
WIMAN radio modem. Before you alter the factory-installed
preset passwords make sure to jot down the new passwords and
store them in a safe place.
3.5.1 Setting of a Password for the Authorization Level
one (console)
To change/set a password for the authorization level one:
1. Access the command line level one. If the command line
prompt appears (for example:
WIMAN II >
), proceed to
No.2.
If you are asked for a password, e.g.:
Enter password: ****
Type in the correct password and press the ENTER-
key. Now the command line prompt should appear, for
example:
WIMAN-II > _