User Manual

39 / 90l
3 Configuration of the WIMAN radio modem
-
Transfer the modifications to the non volatile configuration
and to leave the command mode by pressing the key "y",
-
Discard the modifications and leave the command mode by
pressing the key “n“ or
-
Don’t take over the modifications but stay in command
mode and redo some modifications by pressing the key “c”
To set up the extended parameters for the wireless interface:
Attention:
In order to avoid disturbances in the current line operation, only
qualified personnel in arrangment with the Provider may carry
out these modifications.
Checklist:
You need a list of the parameters configured by your Provider.
1. Access the command line level of the authorization level
two (see chapter 2 on page 13) and change into the configu-
ration mode with the command config.
2. Proceed as shown under point 2. during adjustment of the
base parameters and replace thereby the term " authoriza-
tion level one " with " authorization level two ".
3.4.2 Setup of the Parameter of the serial interfaces
The adjustments of the parameters for the serial interfaces can
basically be divided into the following two categories:
• Basic parameter and
• extended parameter.
The only base parameter that can already be modified in au-
thorization level one (e.g. of the final customer) is ConBaudrate
(see page 21).
All other parameters (see chapter 2 starting from page 13) may
exclusively be modified in authorization level two.
To set the parameters of the serial interfaces:
Proceed as shown in Chapter 3.4.1 on page 36
3.4.3 Setup of the network parameter
The setting of the network parameters can exclusively be exe-
cuted in the authorization level two. You will find the defini-
tions of the individual parameters in chapter 2 starting on
page 23.