User Manual

38 / 90
3 Configuration of the WIMAN radio modem
6. In order to transfer the modifications into the current con-
figuration leave the configuration mode with exit (see
page 27).
The following display output appears::
Configuration changed, do you want to save (y)es
/ (n)o / (c)ancel ?
You now have the choice to do one of the following:
-
Transfer the new configuration to the current configuration
and to leave the configuration mode by pressing the key " y,
-
Leave the configuration mode without transferring the new
configuration to the current configuration by pressing the
key " n "
-
Remain in the configuration mode and repeat the configura-
tion or do another modification of parameters (if necessary)
by pressing the key " c ".
In order to maintain the values after a restart it is necessary to
store them in the non-volatile configuration. This can be done in
two ways:
• With input of the command save (see page 28) in the com-
mand mode.
All modifications made at this configuration are stored in
the non-volatile configuration and are available after a re-
start.
The command-mode will not be left.
• With input of the command exit (see page 17) in the com-
mand mode.
When leaving the command mode the WIMAN radio mo-
dem checks whether the present configuration modifica-
tions are available for non-volatile configuration. Since you
made some modifications the following display output ap-
pears:
Boot config differs from running config, save
(y)es / (n)o / (c)ancel ?
You now have the choice to do one of the following: