User Manual

37 / 90l
3 Configuration of the WIMAN radio modem
2. Type in the command show.
You will receive a list of the changeable parameters in au-
thorization level one e.g. in the following display output:
WIMAN_Star (config) > show
Config mode running config ( new config)
# Wireless
NetId 250
NodeId 0
# Serial
SerBaudrate 2048000
# Console
ConBaudrate 9600
# Network
IPSerAddress 192.168.40.2
IPSerMask 255.255.255.224
All changeable parameters for the wireless interface are
listed under the category “#Wireless”.
3. Modify the parameters according to the specifications of
your Provider. Type in the parameter, followed by a blank,
next add the value of the parameter and press ENTER.
NetID 255 ↵
NodeId 2 ↵
4. Check with checkcfg whether all values for the parameters
were input correctly. If the inputs were correct, you will re-
ceive the following display output:
WIMAN-II (config) > checkcfg
parameter check successful
In case of an incorrect input you receive an error message
with output of the accepted parameter e.g.:
wimanii (config) > checkcfg
bad value: NodeId
configuration invalid
5. Type in the instruction show again to compare the input
values with the values given by your Provider. The new
configuration of the parameter is displayed in parentheses.
Access_01 (config) > show
Config mode running config ( new config)
# Wireless
NetId 250 ( 255)
NodeId 1 ( 2)