User Manual

2 The WIMAN Command Line Level
32 / 90
• sync
supplies information about the synchronization status of the
WIMAN.
• sysmsg
supplies a list with system messages
• syserr
supplies the system error list
• hw
supplies a list with hardware statistics
• sw
supplies a list of software statistics
• tp
supplies traffic information for the wireless hardware driver
• lbt
listen before talking
• con
supplies login-information about the wireless connection
• eth
supplies information about the ethernet connection
• date
supplies information about the time and date
• update
supplies information about the status of a TFTP-update
The parameters serial, fr, wl and qos can supply extended in-
formation by adding the switch <ext> to the instruction, e.g.
stat wl1 ext.
By adding the switch cont=<x> you can achieve continuous
output. The <x> gives the amount in seconds how fast the up-
date-interval of the output shall be. This function is especially
useful when performing a looptest, e.g. stat qos1 cont=2 dis-
plays information about the Quality of Service on the wireless
interface 1 in continuous mode. The display is updated every 2
seconds.
The instruction Clear stat <type> sets the counter statistics-
display of the device specified with <type> back to zero. The
setting of <type> to ALL clears all statistics.
Clear stat <type>