Specifications

SawFeatures
Refer to Figure 1 for key features of the
14-lnch Vari-Speed Vertical Band Saw.
Blade Tension
Hand Wheel
Upper
Wheel
Door
Speed
And
Pitch
Selector
Guide
Rod
Hand
Wheel
Work
Lamp
Lower
Wheel
Door
~
~
~
~
~
Lube
Fitting
Chip Pan
(inside door)
8
Figure 1: Saw Features
Setup and Operation
Installation
The frame of the vertical band saw has four
mounting holes in the base of the saw frame.
The band saw may be secured to the floor using
the four mounting holes.
Electrical Connection
Refer to the Wiring Diagram section for wiring
information. Connection to electrical power
should be made by a qualified electrician.
OperatingInstructions
Controls (Refer to Figure 2)
ON/OFF
Switches
Tum Counter-
Clockwise To
Decrease Speed
==
Tum
Clockwise
To Increase
Speed
Variable
Speed Crank
(turn only when
saw is operating)
Figure 2: Operating Controls
The operating controls for the saw are located on the
left side of the machine. The controls include the
following:
1. A set of start/stop push buttons, located belowthe
optionalwelder, provide a means to start
and stop the saw drive motor.
2. A variable speed control (crank), which can only
be adjusted while the saw is running, is located
belowthestart/stopbuttons.
3. A bladetensioning handwheel is mounted on
the top of the saw enclosure.
4. Refer to Optional Blade Welder for a descrip-
tion of the welder controls.
Optional Blade Welder
An optional bladewelder is availableon the Model
8014 vertical band saw. The welder has all the
features requiredto cut, weld, and anneal the
saw blade.