Specifications

Replacement of Blade Guides
(Refer to Figure 9)
1. When removing upper blade guides, remove
blade guard from guide support.
2. When removinglower bladeguides, open lower
left door to access the blade guides (the lower
blade guard is attached to the lower door).
3. Remove cap screws and washers from bothblade
guides.
4. Removebladeguides.
5. Install new blade and secure with cap screws
and washers.
6. Adjust blade guides so they just touch the side of
the saw blade. Adjust position of guide seat so it
just touches the back edge of the blade.
Figure 9: Replacementof Blade Guides
Adjustments
Work Table
The position work table can be adjusted to tilt either
left or right (approximately 10 degrees in either
direction) The work table can also be adjsuted to tilt
approximately 45 degrees to the rear and 15 degrees
to the front).
Frant/Back(Refer to Figure 10):
Loosen hex nut and tilt table to the desired position.
Tighten hex nut.
, \
\
'\~ Table
\ 0 \ \ \ ' -------------
Position Tab~--
\~\'\ ~ \ at Desired Angle / - .'---
"
~
\ I
/ s=r IL,
J~l'
/C-- '
~
"
I
I
\
r-'
,
"'/
,
" , -A
I
~, ,§J ""-I~I I
~El3~
1
~ 1-1 Nut!
~i I I Loosen~~ --1. -
'--'-- 'i(
II
Figure 10: Table Adjustment (Front/Back)
Right/Left (Refer to Figure 11):
Loosen two screws. Using the adjustment knob, tilt
the table to the desired position. Tighten two screws.
Table
~ ,-~
c ~~;-~
~1\\\ \
I
/
0
II
'7
/
) IAngle r#"L;\ '{,ll / /
,
~
Adjustmen
,
t'''? ''i0
,
'
I I
:J
'
;
1 /'-.'./
j
~
I
Knob ~. I 1...lJ1
~..~.
?\~,~
1
I
11
(x, 0
,
// 1
,
111 ,L -
,
'
,
~
,
~:~~
~~~(:: I ~I (2)
Jt'< <~I ~! !I ~;~j
1 ' , -
13
Figure 11: Table Adjustment (Right/Left)