Specifications

AdjustingPlatenHousing
Position
The sanding belt can be operated with the platen
housing horizontal, vertical, or at any angle in
between. Change position of the platen housing as
follows:
WARNING: DISCONNECT ELECTRICAL POWER
TO THE MACHINE BEFORE PERFORMING ANY
MAINTENANCE.
1. Disconnectelectricalpower.
2. Removefourscrews (52)and pulleycover(12).
3. Usingan open end wrench, loosentwo hex
screws (13) (referto Figure7).
4. Movethe platen housingto the desiredposition.
When the platen housing is to be placedin the
horizontalposition,lower the platen housingonto
stop screw (28) on the machine base.
5. If the stop requiresadjustment, loosenjam nut
(29), adjust stop screw (28)to desired position,
and tighten nut (29).
6. Tighten two hex screws (13).
7. Installpulleycover (12)and securewithfour
screws (52).
8. Start the machineto check operation.
Clamping
Screws
Figure 7. Platen Housing Clamping Screws
Adjusting the Sander Tables
The belt and disc sander tables can be adjusted
from 0 to 45 degrees to accommodate the work
piece.
Disc Table
1. Tochange the disc table angle, loosenthe knob
on the left side of the table (referto Figure8).
2. Movethe table to the desiredangle.
3. Tighten the knobto securethe table.
Table Clamping Knob
Figure 8. Adjusting Sander Table Angle
Belt Table
9
1. To change the belt table angle, loosenthe knob
on the right side of the platen housing (referto
Figure8).
2. Movethe table to the desiredangle.
3. Tighten the knob to secure the table.