Use and Care Manual

CONTACT ADHESIVE

WATER-BASED

*GREENGUARD® Certied

*Complies with SCAQMD, Rule 1168

*Qualies for LEED®-NC & CI EQ Credit 4.1:

Low Emitting Materials: Adhesives & Sealants

*Qualies for LEED®-NC & CI EQ Credit 4.4:

Laminating adhesives shall contain no added urea-formaldehyde resins.

WATER-BASED

CONTACT ADHESIVE

NON-FLAMMABLE!

• Consumer or professional use

• GREENGUARD

Indoor Air Quality Certiﬁed®

• Spray or Roller Applied

• Non-Toxic

• Postforming or Flatwork

Applications

• Extremely Low VOC

& VHAP Content

• Available sizes:

275-gallon tote (returnable)

55-gallon drum

5-gallon pail

1-gallon jug

1-quart bottle

Physical Properties

Color: White or Green

Odor: Slight ammonia

Density: 9.1 pounds/gallon

Solids Content: 52.0% ± 2.0%

pH: 10-12

VOC*: <0.1 grams/liter (Calculated)

*Less water & exempt solvents

VHAP Content: < 0.035 lbs./lbs. solids

Coverage (Spray): 357 bonded ft

/gal @ 3 dry grams/ ft

Freeze Stable: No

Dry Time:

20-30 minutes or 8-10 minutes using forced air

Open Time: Approximately 1 hour

PAGE 1
Physical Properties Color: Odor: Density: Solids Content: pH: VOC*: WATER-BASED CONTACT ADHESIVE NON-FLAMMABLE! White or Green Slight ammonia 9.1 pounds/gallon 52.0% ± 2.0% 10-12 <0.1 grams/liter (Calculated) *Less water & exempt solvents VHAP Content: < 0.035 lbs./lbs.
PAGE 2
• Use ammoniated cleaners before adhesive film cures. • Use WA 110 solvent to clean dried, cured adhesive from equipment. • Use WA 121 to clean dried, cured overspray from finished assembly. DO NOT USE WA 121 TO CLEAN EQUIPMENT! • Dispose of waste in accordance with regulations. General Description A non-flammable waterborne system of polychloroprene rubber and resins. Extremely low VOC and VHAP content. This product does not require stirring before use.