SDS

Wilsonart H2O Adhesive
Safety Data Sheet
Prepared according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations
12/11/2015
Wilsonart H2O
Adhesive
3/1
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Benzene, 1,1'-oxybis-, tetrapropylene derivatives, sulfonated, sodium salts (119345-04-9)
Remark (ACGIH)
OELs not established
Remark (OSHA)
OELs not established
8.2. Exposure controls
Appropriate engineering controls : Provide adequate general and local exhaust ventilation. Use process enclosures, local exhaust
ventilation, or other engineering controls to control airborne levels below recommended
exposure limits. Use explosion-proof equipment with flammable materials. Ensure adequate
ventilation, especially in confined areas.
Personal protective equipment : Gloves. Protective goggles. Wear chemically impervious apron over labcoat and full coverage
clothing.
Hand protection : Use gloves chemically resistant to this material when prolonged or repeated contact could
occur. Gloves should be classified under Standard EN 374 or ASTM F1296. Suggested glove
materials are: Neoprene, Nitrile/butadiene rubber, Polyethylene, Ethyl vinyl alcohol laminate,
PVC or vinyl. Suitable gloves for this specific application can be recommended by the glove
supplier.
Eye protection : Wear eye protection, including chemical splash goggles and a face shield when possibility
exists for eye contact due to spraying liquid or airborne particles.
Skin and body protection : Wear long sleeves, and chemically impervious PPE/coveralls to minimize bodily exposure.
Respiratory protection : Use NIOSH-approved dust/particulate respirator. Where vapor, mist, or dust exceed PELs or
other applicable OELs, use NIOSH-approved respiratory protective equipment.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
9.2. Other information
VOC content : < 20 g/l
Physical state
:
Liquid
Appearance
:
White mobile liquid
Color
:
White.
Odor
:
Slight. Ammonia-like.
Odor Threshold
:
No data available
pH
:
10 - 12
Relative evaporation rate (butylacetate=1)
:
No data available
Melting point
:
Similar to water
Freezing point
:
No data available
Boiling point
:
Similar to water
Flash point
:
No data available
Auto-ignition temperature
:
No data available
Decomposition temperature
:
No data available
Flammability (solid, gas)
:
No data available
Vapour pressure
:
Equivalent to water
Relative vapour density at 20 °C
:
Equivalent to water
Relative density
:
1.09 (~ 9.1 lb/gal)
Solubility
:
Soluble in water.
Log Pow
:
No data available
Log Kow
:
No data available
Viscosity, kinematic
:
No data available
Viscosity, dynamic
:
No data available
Explosive properties
:
No data available
Oxidising properties
:
No data available
Explosive limits
:
No data available