SDS

High Tack Contact Adhesive
Safety Data Sheet
Prepared according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations
04/19/2017
High Tack Contact Adhesive
3/8
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
General measures
:
Evacuate area. Keep upwind. Ventilate area. Spill should be handled by trained clean-up crews
properly equipped with respiratory equipment and full chemical protective gear (see Section 8).
Avoid vapor formation. In case of spills, beware of slippery floors and surfaces. Eliminate all
sources of ignition.
6.1.1. For non-emergency personnel
Protective equipment
:
Wear Protective equipment as described in Section 8.
Emergency procedures
:
Evacuate unnecessary personnel.
6.1.2. For emergency responders
Protective equipment
:
Wear suitable protective clothing, gloves and eye or face protection. Approved supplied-air
respirator, in case of emergency.
6.2. Environmental precautions
Prevent entry to sewers and public waters. Avoid release to the environment.
6.3. Methods and material for containment and cleaning up
For containment
:
Contain any spills with dikes or absorbents to prevent migration and entry into sewers or
streams.
Methods for cleaning up
:
Remove all sources of ignition. Avoid breathing of vapors. Wear appropriate respirator and
other protective clothing. Ventilate. Shut off source of leak only if safe to do so. Soak up with
absorbent material, and place in non-leaking containers for proper disposal.
6.4. Reference to other sections
No additional information available
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Precautions for safe handling
:
Keep away from heat, sparks and open flames. Use adequate ventilation and avoid repeated or
prolonged skin contact. Wash hands and other exposed areas with mild soap and water before
eating, drinking or smoking and when leaving work. Provide good ventilation in process area to
prevent formation of vapour. Ground/bond container and receiving equipment. Prohibit smoking
in storage area.
7.2. Conditions for safe storage, including any incompatibilities
Storage conditions
:
Store in a well-ventilated place. Keep container tightly closed. Isolate from oxidizers, heat,
sparks, electrical equipment and open flame. Closed containers may explode if exposed to
extreme heat. Store in a cool dry place. Prohibit smoking in storage area. Do not store with
acids or oxidizers. Electrical service in storage area must be rated for flammable liquids.
7.3. Specific end use(s)
No additional information available
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Cyclohexane (110-82-7)
ACGIH TWA (ppm)
100 ppm
OSHA PEL (TWA) (mg/m³)
1050 mg/m³
OSHA PEL (TWA) (ppm)
300 ppm
Isopentane (78-78-4)
ACGIH TWA (ppm)
600 ppm (listed under Pentane, all isomers)
Remark (OSHA)
OELs not established
Pentane (109-66-0)
ACGIH TWA (ppm)
600 ppm (listed under Pentane, all isomers)
OSHA PEL (TWA) (mg/m³)
2950 mg/m³
OSHA PEL (TWA) (ppm)
1000 ppm
Hexane (110-54-3)
ACGIH TWA (ppm)
50 ppm
OSHA PEL (TWA) (mg/m³)
1800 mg/m³
OSHA PEL (TWA) (ppm)
500 ppm