Use & Care Guide

Precautionary Information
Refer to product label and material safety data sheet for Health &
Safety information before using this product.
Warranty
NO WARRANTY: WILSONART MAKES NO WARRANTIES, EXPRESS OR
IMPLIED. NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE SHALL APPLY. The person using the product (the
“User”) is solely responsible for determining whether the Wilsonart product is
appropriate and/or suitable for User’s purpose and method of application.
LIMITATION AND EXCLUSION OF REMEDIES AND DAMAGES: The
exclusive and sole remedy, and Wilsonart’s exclusive and sole obligation,
for any defect of this Wilsonart product is the refund of the purchase price of
the product. Wilsonart shall not, under any circumstances or under any legal
theory, be liable to the Purchaser or any other person for special, incidental or
consequential damages of any nature, including without limitation damages
to, or loss of use of, property, damages for loss of profits or revenues or any
other damages arising from the purchase or use of the product. Wilsonart’s
liability will in no event exceed the purchase price of the product
Contact
Customer Service: 1-800-433-3222 or [e-mail]
Visit www.wilsonartadhesives.com for information
CONTACT ADHESIVE
WATER-BASED
©2013 Wilsonart LLC
Rev. 5/2013
Clean-up/Disposal
• FOR BEST RESULTS, CLEAN EQUIPMENT AND EXCESS ADHESIVE
IMMEDIATELY WITH COLD WATER. DO NOT ALLOW TO DRY.
• Use ammoniated cleaners before adhesive film cures.
• Use WA 110 solvent to clean dried, cured adhesive from equipment.
• Use WA 121 to clean dried, cured overspray from finished assembly.
DO NOT USE WA 121 TO CLEAN EQUIPMENT!
• Dispose of waste in accordance with regulations.
Primary Contents
Zinc oxide (CAS 1314132), Water (CAS 7732185), Polychloroprene
(CAS 9010984), Resin Acid & Rosin Acid in Sodium and Potassium
formm (CAS N/A)