Specification

Guide Specification
Revision: 10/19/2015 Section 06 0630 - 5
Decorative Plastic Laminate Resurfacing
EDITING NOTE: If color, pattern, and finish are not specified above, delete and select
one of the following options.
PART 2 - PRODUCTS
2.01 MANUFACTURER
A. Basis of Design: Wilsonart.
2.02 LAMINATE PROPERTIES
A. Laminate Composition: Decorative surface papers impregnated with melamine resins and
pressed over kraft paper core sheets impregnated with phenolic resin. Sheets then
bonded together under pressures greater than 1,000 lbs. per sq. in. and high
temperatures approaching 300 deg F (149 deg C). Finished sheets trimmed and backs
sanded to facilitate bonding to substrate.
B. Sustainable Design Conformance Standards:
1. UL 2818 GREENGUARD Gold Certified.
2. SCS Certified Indoor Air Quality Advantage™ Gold Certified.
3. SCS Chain of Custody Certified for FSC
®
Mix, FSC Controlled Wood.
4. SCS Recycled Content Certified.
2.03 VERTICAL SURFACE LAMINATES
A. Product: “Wilsonart
®
RE-COVER
TM
Laminate Type 735.”
1. Sheet Thickness: 0.032 inch nominal.
2. Sheet Width: 36, 48, and 60 inches.
3. Laminate Conformance Standard: NEMA LD 3, Grade VGS.
4. Applications: Vertical surfaces only. [For radiused applications, a minimum
radius of 7 inches is required.]
5. Edging: Self-edged.
6. Color, Pattern, and Finish: [________________________].
7. Color, Pattern, and Finish: Specified in SCHEDULE Article of this Section.
8. Color, Pattern, and Finish: Indicated on Drawings.
9. Color, Pattern, and Finish: Selected from manufacturer's full range of available
selections.
B. Product: “Wilsonart® RE-COVER™ Chalkboard Type 737.”
1. Sheet Thickness: 0.049 inch.
2. Sheet Width: 48 inches
WILSONART CONTACT INFORMATION: Wilsonart, 2501 Wilsonart Drive, Temple, TX 76503-
6110. Tel. [phone], Toll-Free 800.433.3222, Fax [phone].
Website: www.wilsonart.com
EDITING NOTE: Refer to the Laminate Design Detail Page on the Wilsonart website for complete
information on laminate properties, including applicable sustainable design conformance standards,
compliance with additional standards, physical performance properties, and available sheet sizes.