Specification

Guide Specification
Revision: 10/19/2015 Section 06 0630 - 3
Decorative Plastic Laminate Resurfacing
E. Quality Assurance Submittals:
1. Test Reports: Certified test reports showing compliance with specified
performance characteristics and physical properties, if required.
2. LEED Submittals: Applicable LEED documentation for potential credits specified
in this Section.
F. Maintenance Data: Manufacturer’s published maintenance manual with closeout
submittals.
1.05 REGULATORY REQUIREMENTS
A. Adhesives, Sealants, and Sealant Primers:
1. SCAQMD (South Coast Air Quality Management District) Rule 1168 for VOC
content.
2. Ozone Transport Commission (OTC) model Rule for Adhesives and Sealants.
1.06 QUALITY ASSURANCE
A. Qualifications:
1. Manufacturer Qualifications: Manufacturer producing products in an ISO 9001,
ISO 14001, and OHSAS 18001 certified facility.
2. Fabricator Qualifications: Minimum of three years documented experience in
fabricating decorative plastic laminates similar in scope and complexity of this
Project.
3. Installer Qualifications: Minimum of three years documented installation
experience for projects similar in scope and complexity to this Project. [Installer
shall be the fabricator].
B. LEED 2009 rating system potential credits for plastic laminate:
1. [LEED-NC] [LEED-CI] MR Credit 4 - Recycled Content.
2. [LEED-NC] [LEED-CI] MR Credit 5 - Regional Materials.
3. [LEED-NC] [LEED-CI] MR Credit 6 - Rapidly Renewable Content.
4. [LEED-NC] [LEED-CI] MR Credit 7 - Certified Wood.
5. [LEED-NC] [LEED-CI] IEQ Credit 4.4 - Low-Emitting Materials - Composite
Wood and Agrifiber Products.
6. LEED-CI IEQ Credit 4.5 - Low-Emitting Materials, Systems Furniture and
Seating.
C. LEED 2009 rating system potential credits for Wilsonart
®
Adhesives:
1. [LEED-NC] [LEED-CI] IEQ Credit 3.2 - Construction Indoor Air Quality
Management Plan - Before Occupancy.
2. [LEED-NC] [LEED-CI] IEQ Credit 4.1- Low Emitting Materials - Adhesives and
Sealants.
3. [LEED-NC] [LEED-CI] IEQ Credit 4.4 Low-Emitting Materials - Composite Wood
and Agrifiber Products.
EDITING NOTE: Following two LEED paragraphs list potential credits according to LEED
2009 for New Construction & Major Renovations (LEED-NC) and LEED 2009 for
Commercial Interiors (LEED-CI). Coordinate with designated Project LEED AP for credits
applicable to Project.