Specification

Guide Specification
Revision: 10/19/2015 Section 06 0630 - 10
Decorative Plastic Laminate Resurfacing
B. Prior to installation, and before removing peel sheet that covers laminate adhesive, dry fit
laminate to substrate. After peel sheet is removed, apply uniform bonding pressure (30 to
40 psi minimum) over the entire bonded surface, using an approved roller.
1. Resurfacing laminate is NOT repositionable. Any attempts to reposition the
laminate will result in inadequate bonding.
C. Where self-edging is required, comply with resurfacing laminate manufacturer’s printed
installation instructions, including recommended adhesive.
3.05 CLEANING AND PROTECTION
A. Clean decorative plastic laminate according to manufacturer’s printed care and
maintenance instructions.
B. Protect installed products and finish surfaces from damage during remainder of
construction period.
3.06 SCHEDULE
END OF SECTION 06 0630
OPTION: Color, Pattern, and Finish Schedule may be inserted here if this option is chosen.