Specifications

NAIROBI OPERATIONAL HUB
UNOPS Building, UN Lane, Off UN Avenue Tel: [phone]
P.O Box 783,Village Market, 00621 E-mail: [e-mail]
Nairobi, Kenya Website: www.unops.org
UNOPS is ISO 9001 certified
A. Prior to starting the electrical installation, the Contractor shall verify the correct
voltage, phases and current consumption of all utilization equipment to be
voltage, phases and current consumption of all utilization equipment to be
connected. Branch circuit wiring, voltage and circuit breakers must be adequate in
each case.
B. The contractor shall provide any materials, equipment and labor required and
make such tests as specified in the various sections of Division 16 and as deemed
necessary to show proper execution of the work.
C. Any defects or deficiencies discovered as a result of such tests shall be corrected
without additional cost.
D. After the installation is complete and properly adjusted, the Contractor shall
conduct operating tests. The various equipment and systems shall be
demonstrated to operate in accordance with the requirements of the Contract
Document. The Contractor shall provide electric power, instruments and
personnel necessary for performing the various tests.
3.09 Equipment Connections and Motor Starters
A. In addition to electrical work, the Contractor shall make all electrical connections
to mechanical and medical equipment furnished under other sections i.e. the
Plumbing, Heating, Air Conditioning and Ventilation Sections of Division 15.
B. Unless otherwise specified, the Contractor shall mount and align all starters,
control devices, safety switches and other related electrical equipment whether
specified in this or other sections of the specification, except where such items are
factory mounted to the driven equipment. The mounting and alignment of motors,
starters, control equipment etc.., for which the feeders are terminated in safety
switches as hereinafter specified, are included in the sections of Mechanical
Sections, in which the motors etc.., are specified.
C. Unless otherwise specified, the Contractor shall furnish all wiring, including
conduit, wire, junction boxes, disconnecting switches, overcurrent protection,
etc.., not specified elsewhere in this specification, to and between all motors,
starters, control devices and related electrical equipment whether specified in this
or other sections of the specification, except where such items are factory wired as
well as factory mounted on the driven equipment. All wiring from the above