Specifications

NAIROBI OPERATIONAL HUB
UNOPS Building, UN Lane, Off UN Avenue Tel: [phone]
P.O Box 783,Village Market, 00621 E-mail: [e-mail]
Nairobi, Kenya Website: www.unops.org
UNOPS is ISO 9001 certified
E. All items of labor and material required to comply with such standards and codes
in accordance with the requirements of the Contract Documents shall be
included. Where quantities, sizes or other requirements indicated on the drawings
or herein specified are in excess of the requirements of the standards and codes,
the specifications and /or drawings shall govern.
F. The electrical drawings shall serve to indicate the general layout of the various
items of equipment. However, layout of equipment, accessories, specialties and
wire ways are diagrammatic unless specifically shown and /or dimensioned.
G. The General arrangement of circuiting and equipment shall be as shown on the
drawings. Detailed drawings and proposed deviations due to actual field
conditions or other causes shall be submitted to the Supervising Engineer for
review. The Contractor shall carefully examine all drawings and shall be
responsible for the proper fitting of materials and equipment in each location as
indicated, without substantial alterations. The Contractor shall carefully
investigate the structural and finish conditions affecting his work and shall
arrange such work accordingly, furnishing such fittings and accessories as may be
required to meet such conditions.
H. The motor and apparatus wattage ratings shown on drawings are estimated values.
The corresponding sizes of feeders and other electrical equipment indicated to
serve them shall be confirmed by the Contractor. Motors and apparatus with
larger wattage ratings may be furnished if necessary to meet the requirements of
the various sections of the specification in which they are specified. Where larger
motors or apparatus with larger wattage ratings are furnished, the feeders and
other electrical equipment serving them shall be suitably increased. The increase
in the capacity of the feeder and equipment shall be furnished at no additional cost
to the Client.
1.03 Submittals
A. Shop Drawings: The Contractor shall submit for review by the Supervising
Engineer, detailed dimensioned shop drawings as stipulated in other sections of
Specification Division 16, Electrical. These drawings shall be prepared by the
Contractor, shall base on manufacturers installation instructions and shall not be
reproductions or tracings of the design drawings. In preparing shop drawings,
lines and levels for the work specified shall be established and the drawings shall
be checked thoroughly to avoid interference with structural features and the work
of other trades. Shop drawings and /or data sheets shall be based on information