Specifications

13
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
14
About Wilson Electronics
Wilson Electronics, Inc. has been a leader in the wireless communications industry
for over 40 years. The company designs and manufactures Signal Boosters,
antennas and related components that significantly improve cellular phone signal
reception and transmission in a wide variety of applications, both mobile (marine,
RV, vehicles) and in-building (home, office, M2M).
With extensive experience in antenna and Signal Booster research and design, the
company’s engineering team uses a state-of-the-art testing laboratory, including
an anechoic chamber and network analyzers, to fine-tune antenna designs and
performance. For its Signal Boosters, Wilson Electronics uses a double electrically
insulated RF enclosure and cell tower simulators for compliance testing.
Wilson Electronics Signal Boosters feature patented Smart Technology
™
that
enables them to automatically adjust their power based on cell tower requirements.
By detecting and preventing oscillation (feedback), signal overload and interference
with other users, these Smart Technology
™
Signal Boosters improve network cell
phone areas without compromising carrier systems.
All products are engineered and assembled in the company’s 55,000-square-foot
headquarters in St. George, Utah. Wilson Electronics has product dealers in all 50
states as well as in countries around the world.
Warnings and Recommendations
Warning: The Directional Antenna must always be located so the back or
side points to the Inside Antenna. Never point the front of the
Outside Antenna toward the Inside Antenna – this is to prevent
oscillation.
Warning: Connecting the Signal Booster directly to the cell phone with use of
an adapter will damage the cell phone.
Warning: Use only the power supply provided. Use of a non-Wilson
Electronics product may damage your equipment.
Warning: RF Safety: FCC regulations require that any fixed Outside
Antenna used with this Signal Booster may not have gain (less
cable loss) that exceeds 15 dBi and must be located at least 30
inches from all people. Inside Antennas must not exceed 7 dBi
gain (less cable loss) in the 800 MHz band or 10 dBi gain (less
cable loss) in the 1900 MHz band and must be located at least
15 inches from all people.
Warning: Verify that both the Outside Antenna and the Inside Antenna are
connected to the Signal Booster before powering up the Signal
Booster.
Recommendation: Lightning Surge Protection is recommended
for all in-building installations.