Datasheet

7
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
Or email: [e-mail] Hours: 7am to 6pm MST.
8
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
Or email: [e-mail] Hours: 7am to 6pm MST.
Make sure both the Outside Antenna and
Cellular Cradle Plus or Ultra Slim Antenna
cables are connected before powering up
the Signal Booster.
Connect the power cable from the power
supply to the Signal Booster input marked
“12 V DC” and insert the large end into the
power socket or the vehicle power outlet.
The Signal Booster may remain on all the
time. However, leaving the Signal Booster
on in a vehicle when it is not running can
discharge the battery in a day or two.
A good option is to power the Signal
Booster through the ignition switch so the
Signal Booster is turned on and off with the
vehicle.
Carefully insert the power cable
(Power supply may change due to upgrades)
IMPORTANT: Do not power up the Signal
Booster unless both antenna cables are
attached to the Signal Booster.
Warning: Use only Wilson
Electronics power supply units. Use
of a non-Wilson Electronics product
may damage your equipment.
!
AC/DC power supply (sold separately) (859903)
Note: The aluminum casing of the Signal Booster will adjust very quickly to the ambient
temperature of its environment. For example, in the summer, when the inside of a car
can reach 140° Fahrenheit, the Signal Booster temperature may be 150° or higher. The
casing will be hot to the touch, similar to a metal door handle or steering wheel. Such
high temperatures will not damage the Signal Booster, nor do they pose a fire risk. As
recommended in these instructions, when installing the Signal Booster in a vehicle, select
a location with adequate ventilation, such as under the seat or dashboard. Keep the area
free of items that could block air flow to the Signal Booster.
Powering Up the Signal Booster
Installing the Outside Antenna
To receive the best cell signal, select a window location at least 12 inches away from any
radio or television antennas and free of obstructions.
Using the suction cups, position the mounting bracket on the
window at a height convenient to where the Signal Booster will
be located, then attach the antenna to the bracket.
The antenna must be installed vertically. Signal performance will
be degraded if the antenna is not vertical.
Select a location to install the Signal
Booster that is away from excessive heat,
direct sunlight or moisture and that has
proper ventilation.
Recommended installation locations are:
• On a desk or table top
• In a bookshelf
• On the floor
In-Building
Installing the Wilson Electronics Signal Booster
Warning: The antenna used with this Signal Booster must
have a separation distance of at least 12 inches from all
persons.
!
Warning: Do not plug in the AC power
supply until both antenna cables are
attached to the Signal Booster.
!
In-Vehicle & In-Building
Wilson
®
Electronics recommends that all AC power
supplies for home electronics be plugged into a
Surge Protector Power Strip.
Run the cable from the Outside Antenna
and attach it to the connector labeled
“Outside Antenna” on the Signal Booster.
Attach the Cellular Cradle Plus or Ultra
Slim cable to the connector labeled “Inside
Antenna” on the Signal Booster.
Then attach the Cellular Cradle Plus or
Ultra Slim to your cell phone or data card.
(See page 5 & 6.)