User's Manual

7
Installing the Wilson Universal Connector
The universal connector must be placed
directly on the cell phone or cellular data
card to work properly. Attach the universal
connector to the cell phone or cellular data
card with the VELCRO
®
included in the
package.
The universal connector and extension
cable included in the package are long
enough to reach the amplier location. This
allows for ease and convenience of use.
To adjust the universal connector for the
best signal, go to a weak signal location
where your cell phone registers only 1-2 bars
without the universal connector connected.
(Be sure the amplier is turned off when
checking for low signal.) Then, attach the
universal connector to the phone, power up
the amplier and you should see a signal
improvement of 2 or more bars.
Note: Many phones take up to 20 seconds
to reset the bar indicator.
To maximize performance, attach the universal
connector as close as possible to the original
antenna on your cell phone or cellular data card.
For cell phones with no external antenna, place
the universal connector on the back, upper left-
hand corner of the phone. (Figure 1)
For cell phones with an external antenna, place
the universal connector directly below the
phone’s original antenna. (Figure 2)
Many of the hands-free cradles have a built-in
antenna with a pigtail. If using a hands-free
device or cell phone cradle, the universal
connector may be directly connected to the
phone cradle or to the pigtail.
Amplier 6’ Extension
Cable
Universal
Connector
Figure 1
Figure 2
To Amplier
Cellular data card