User's Manual

6
Installing the Antenna
To receive the best cell signal, select a window location at least 12 inches away from any
radio or television antennas and free of obstructions.
Using the suction cups, position the
mounting bracket on the window at a height
convenient to where the amplier will be
located, then attach the antenna to the
bracket.
The antenna must be installed vertically.
Signal performance will be degraded if the
antenna is not vertical.
Select a location to install the amplier that
is away from excessive heat, direct sunlight
or moisture and that has proper ventilation.
Recommended installation locations are:
On a desk or table top
In a bookshelf
On the oor
Run the cable from the mini magnet-mount
antenna and attach it to the FME-Male
connector labeled “outside antenna” on the
amplier.
Attach the universal connector cable to the
extension cable and attach the extension
cable to the FME-Male connector labeled
“Universal Connector” on the amplier.
Then attach the universal connector to your
cell phone or data card.
Home/Ofce Installation
Installing the Wilson SignalBoost™ Amplier
Warning: Do not plug in the AC power
supply until the outside antenna and universal
connector cables are attached to the amplier.
!
Warning: The antenna used with this
amplier must have a separation distance of at
least 11 inches from all persons.
!