User's Manual

5
Installing the Wilson SignalBoost™ Amplier
Warning: Do not plug in the DC
power supply until the antenna and universal
connector cables are attached to the amplier.
!
Select a location to install the amplier that
is away from excessive heat, direct sunlight
or moisture and that has proper ventilation.
Recommended installation locations are:
Under the seat
Under the dash
Run the cable from the antenna and attach
it to the FME-Male connector labeled
“outside antenna” on the amplier.
Attach the universal connector cable to the
extension cable and attach the extension
cable to the FME-Male connector labeled
“Universal Connector” on the amplier.
Then attach the universal connector to your
cell phone or data card.
Vehicle Installation