User's Manual

6
7
8. TECH SUPPORT
If you need further assistance with your installation:
1) Call us Toll-Free at 866-294-1660
2) E-mail tech support at [e-mail]
3) Go to www.wilsonelectronics.com
Our Hours of Operation are: 8:00 AM – 4:30 PM (Mountain Time)
951101 5’ Extension Cable RG 58 Low Loss Coax (0.6 db loss)
951102 10’ Extension Cable RG 58 Low Loss Coax (1.2 db loss)
951103 15’ Extension Cable RG 58 Low Loss Coax (1.8 db loss)
951104 20’ Extension Cable RG 58
Low Loss Coax
(2.4 db loss) Used with the Yagi
Antenna - (N-Male to FME Female)
951108 20’ Extension Cable 9913
Ultra Low Loss Coax
Only use 9913 Low Loss Coax for
extensions 20’ or longer (0.8 db loss)
951105 30’ Extension Cable 9913
Ultra Low Loss Coax
(1.2 db loss)
951106 50’ Extension Cable 9913
Ultra Low Loss Coax
(2.0 db loss)
951107 100’ Extension 9913 Low Loss Coax (4.0 db loss)
EXTENSION CABLE CHART (RG 58 - FME connectors / 9913 - N connectors)
The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations
when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially
where the output signal is re-radiated and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction and not by an attenuator at the output of
the device.
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of this device.
Leaving the amplifier on in an unused vehicle for days may drain your battery. This can be avoided by
plugging into an ignition switched outlet or by using the small white switch located on the power supply.