User's Manual

2
3
4. AMPLIFIER INSTALLATION (see illustration on pg.4)
4.1 Installing the
Wilson Cellular
Antenna
4.1.1 See antenna packaging for model specific instructions.
WARNING: Verify that both the outside antenna and adapter extension cable are
connected before powering up the AMPLIFIER.
RF SAFETY WARNING: (MOBILE ONLY) The outside antenna must be
mounted with a separation distance of at least 15.5 inches from
any of the vehicle occupants or nearby persons and must not be
co-located or operating in conjunction with any other antenna or
amplifier. Use of a cellular amplifier with antenna gains higher
than 5.12dBi is in violation of FCC regulations for which the offender
is fully liable. All Wilson Mobile Antennas are 5.12dBi or less.
WARNING: (IN-BUILDING ONLY)
Lightning protection is recommended for all
in-building installations.
RF SAFETY WARNING: (IN-BUILDING ONLY) When using in-building, the outside
antenna must be fixed-mounted on an outdoor permanent structure with a
separation of at least 20 feet from all persons during normal operation.
4.2 Installing The Amplifier
4.2.1 Select a suitable location to mount the AMPLIFIER.
In vehicle installation - under the dash or vehicle seat
In building installation - on a wall or ceiling
NOTE: Mount the AMPLIFIER away from direct sunlight, excessive heat and/or
moisture. The amplifier needs proper ventilation. DO NOT place the
amplifier in an air-tight enclosure. Use #6 screws to mount the amplifier.
4.2.2 Connect the outside antenna to the AMPLIFIER side labeled “OUTSIDE
ANTENNA”.
4.2.3 Connect the ADAPTER EXTENSION CABLE to the AMPLIFIER side
The information provided by Wilson Electronics, Inc. is believed to be complete and accurate.
However, no responsibility is assumed by Wilson Electronics, Inc. for any business or personal
losses arising from its use, or for any infringements of patents or other rights of third parties
that may result from its use.
Copyright © 2004 Wilson Electronics, Inc.