Datasheet

6
The Wilson Mobile Professional Amplifi er is
designed for installation on the dashboard
of your vehicle, using the supplied adhesive
bracket. Attach the bracket in a suitable
location to the right of the steering wheel.
NOTE: Be sure to select a location for
the amplifi er that does not inhibit your
ability to operate the vehicle safely.
Once you have installed the bracket,
attach the Mobile Professional Amplifi er by
aligning the hole on the back with the hook
on the bracket. Grasping the sides of the
amplifi er, slide it downward approximately
¼ inch into place.
Run the cable from the outside antenna
and attach it to the SMA connector labeled
“antenna” on the amplifi er. Be sure that the
cable does not interfere with your ability to
operate the vehicle safely.
Attaching the Antenna
Installing a Wilson Mobile Professional Amplifi er in a Vehicle
The Wilson Mobile Professional Amplifi er
performs better the closer it is to the cell
phone (with minimum 8-inch separation).
Thus, if you regularly drive through
particularly weak signal areas, you should
consider installing the amplifi er on the back
of the driver’s side headrest.
To do so, attach a strip of Velcro (available
at most hardware or fabric stores) to
the back of the amplifi er and adhere the
matching strip to the back of headrest.
Visually align the strips of Velcro and press
the amplifi er against the headrest so that it
is held in place by the Velcro.
Run the cable from the outside antenna
and attach it to the SMA connector labeled
“antenna” on the amplifi er. Be sure that the
cable does not interfere with your ability to
operate the vehicle safely.
Alternative Amplifi er Installation for Weak Signal Areas