Owner's Manual

weBoost Installed
Discard After Installation
Inside Antenna
BOOSTED SIGNAL
Typical Signal Results
-105 to -90dBm I Good
-9 1 to -85dBm Be tt er
-86 to -65dBm Excellent
Home Complete
Outside Antenna
SIGNAL RECEIVED
Typica l Signal Results
-1 20 to -105dBm I Poor
-104 to -90dBm Fa ir
-89 to -80dBm Goo d
a,
:0
IO
u
X
IO
0
u
♦ The Out si de Ant enna must be at least 50 f ee t horizontal or 20 f ee t ♦
ve rtical distance from Inside Ant enna for best performance
()
0
0)
X
()
0)
c:r
ro
see chart below for recommended see chart be low for r ec omme nd ed
cable lengths for Inside Ant enna - cable lengths for Out side Antenna
-
Booster '-.
RECOMMENDED CABLE LENGTHS
BASED ON OUTSIDE SIGNAL
STRENGTH.
OUTSIDE
SIGNAL STRENGTH
- 110 dBm
-100 dBm
-90 dBm
- 80 dBm
- 70 or higher
MAX CABLE LENGTH
50 fe et
75 f ee t
100 f ee t
125 fe et
150 feet
Note: Minimum coax cable length for
Outside Antenna is 20 feet.
LIGHT PATTERNS
Solid Green
This indicates that your booster is
functioning properly and there are no
issues with installation.
Blinking Green & Red
Band has reduced gain. This indicates
that one or more of the booster bands
has reduced power due to a feedback
loop condition called oscillation. This is a
built -in safety feature to prevent harmful
interference with a nearby cell tower . If you
to pow er
are already experiencing the desired signal
boost, then no further adjustments are
necessary. If you are not experiencing the
desired boost in coverage then refer to the
Troubleshooting section.
Solid Red
Band has shutoff. This is due to a feedback
loop condition called oscillation. This is a
built-in safety feature that causes a band
to shut off to prevent harmful interference
with a nearby cell tower . Refer to Trouble-
shooting section.
Blinking Green & Yellow
Band has reduced gain. This indicates
that one or more of the booster bands
has reduced power due to overload from
nearby cell tower . This is a built-in safety
feature to prevent harmful interference
with a nearby cell tower. If you are already
experiencing the desired signal boost , then
no further adjustments are necessary. If
you are not experiencing the desired boost
in coverage then refer to the Troubleshoot-
ing section.
Solid Yellow
Band has shutoff due to overload from
nearby cell tower . Outside Antenna must