Owner's Manual
Table Of Contents
- Installation Overview
- Installation Guide
- Index
- Package Contents
- STEP 1 Select Mounting Location & Assemble the Outside Antenna
- STEP 2 Mounting the Outside Antenna
- STEP 3 Mounting the Inside Antenna
- STEP 4 Connect Coax Cables to Booster
- STEP 5 Connect Power Supply to Booster
- Booster Light Patterns
- Troubleshooting
- Safety Guidelines
- Antenna Info
- Specifications
- Warranty
Troubleshooting
FIXING BLINKING OR
RED
LIGHT
ISSUES
This section
is
only applicable if
the
Booster
is
red or blinking red and you are not
experiencing
the
desired signal boost.
1 Unplug
the
Booster's
power
supply.
2 Relocate
the
inside and Outside Antenna further from each other. The objective is
to
increase
the
separation distance between them, so
that
they
will
not
create this
feedback condition discussed before.
3 Plug Power Supply
back
in and ensure switch is in ON position.
4 Monitor
the
indicator light
on
your
Booster.
If,
after a
few
seconds
of
'power
on', a solid
or
blinking red light appears, repeat steps 1 through 3. Increase the
separation distance until the condition is corrected and/or desired coverage area
is achieved. Note: Horizontal separation
of
the
two
antennas typically requires a
shorter separation distance than vertical separation.
If you are having any difficulties while testing
or
installing
your
Booster, contact
our
weBoost Customer Support team
for
assistance (866.294.1660).