Owner's Manual
Table Of Contents
- User Manual
- Index
- Package Contents
- Step 1: Mount Outside Antenna & Route Cable
- Step 2: Connect Cable To Outside Antenna
- Step 3: Inside Antenna Location
- Step 4: Booster Location & Connect Cables
- Steps 5 & 6: Power Up The Booster
- Using The Optional Cable Entry Accessories
- Measuring Booster Performance
- Light Patterns
- Troubleshooting
- Antenna Kit Options
- Safety Guidelines
- Specifications
- Warranty
DRIVE X RV CELL PHONE SIGNAL BOOSTER
3
Determine where you want the cable to enter the RV.
NOTE: With this option, we recommend doing a ‘soft install’ before drilling
the hole. Set up the system by routing the cable through an open door or
window, completing the setup instructions, verifying the system works as
desired, and then drilling the hole.
WARNING: Be sure to stay clear of
any power, pipes, etc. that may be
damaged.
Option A: Using existing
cable entry point.
Option B: Through the slider on
your RV (using the slider gasket as
a seal).
Option C: Drill a hole with the
included hole saw bit.
______
(STEP 1: MOUNT OUTSIDE ANTENNA & ROUTE CABLE cont.)