Owner's Manual
Table Of Contents
- User Manual
- Index
- Package Contents
- Step 1: Mount Outside Antenna & Route Cable
- Step 2: Connect Cable To Outside Antenna
- Step 3: Inside Antenna Location
- Step 4: Booster Location & Connect Cables
- Steps 5 & 6: Power Up The Booster
- Using The Optional Cable Entry Accessories
- Measuring Booster Performance
- Light Patterns
- Troubleshooting
- Antenna Kit Options
- Safety Guidelines
- Specifications
- Warranty
10
CELL PHONE SIGNAL BOOSTER DRIVE X RV
866.294.1660
______
Using The Optional Cable
Entry Accessories
NOTE: We recommend putting a loop
going up to the cable entry hole to
prevent moisture from entering the RV.
We strongly recommend using an RTV
sealant from the inside to prevent
moisture, insects, and other undesired
things from entering the RV.
cable
mounts
gasket
Cable Entry
Cover
Skip if you used Option A or B in STEP 1. Pull the RG-6 cable
through the rubber gasket, then place the Cable Entry Cover
into the entry hole (as shown below) and fasten cover to side of
RV. Use the cable mounts and ties to secure to the RV.