A WILSON ELECTRONICS BRAND DRIVE SLEEK Vehicle Signal Booster Kit User Manual NEED HELP? support.weboost.com 866.294.
______ Index Package Contents 1 STEP 1: Mount Outside Antenna 2 STEP 2: Route & Connect Booster 3 STEP 3: Route Cable To Front Of Vehicle 5 STEP 4: Connect System To Power 6 STEP 5: Insert Phone Into Cradle 7 Light Patterns 8 Troubleshooting 9 Safety Guidelines 11 Specifications 12 Warranty 14
________ Package Contents Sleek Cradle Outside Antenna Signal Booster Power Supply DRIVE SLEEK CELL PHONE SIGNAL BOOSTER Magnetic Vent Mount (for cradle) 1
______ Step 1: Mount Outside Magnetic Antenna Identify a location on the top of your vehicle that is: • Near the center of the roof • At least 12 inches away from any other antennas • At least 6 inches away from any windows (including sunroofs) Cle an the surface where you will place the outside antenna. Mount the outside antenna. 6 in.
______ Step 2: Route & Connect Booster Route the cable into the vehicle. See examples below. NOTE: The cable is strong enough that it may be shut in most vehicle doors without damaging the cable. Car/Sedan: Cable routed into rear side door. SUV/Van/Hatchback: Cable routed into top of hatchback door. Truck: Cable routed into side door.
______ (STEP 2 cont.) Connect the cable from the outside antenna to the booster port labeled ANTENNA by simply pressing the connector in until you hear a “click”.
______ Step 3: Route Cable To Front Of Vehicle We recommend routing the 15ft. fixed cable from the booster, under mats and between seats up to the front of the vehicle where the cradle will be located. to front of vehicle Connect booster cable to cable from cradle.
______ Step 4: Connect System To Power Connect the power to the 12V CLA port on your vehicle and route power cable back to the booster. NOTE: We recommend routing with the same path as the cable going up to the cradle (under mats and between seats). connect power supply to 12V port connect to booster Connect power cable to booster port labeled . NOTE: The booster will be on whenever there is power from the 12V CLA ANTENNA port.
______ Step 5: Insert Your Phone Into Cradle Make sure you have plenty of slack in the cable going up to the cradle (velcro straps included to manage excess cable). Insert your phone into cradle and watch your signal increase! insert phone into cradle to boost signal cradle extends magnetic vent mount NOTE: Magnetic vent mount included to mount the cradle to your dash.
______ Light Patterns Solid White This indicates that your booster is functioning properly and at maximum gain. Light Off Needs power. NEED HELP? 8 support.weboost.com 866.294.
______ Troubleshooting FIXING BLINKING LIGHT ISSUES 1 Make sure all connections are tight. 2 I ncrease the distance between the outside antenna and cradle, by moving them horizontally and/or vertically farther apart until the light change to green. Remember to keep the antenna at least 6 inches from any window or sunroof. 3 4 Reset system by disconnecting and reconnecting the power supply.
______ Antenna Kit Options MOBILE Outside Antenna Options Mini-Mag 301126 w/ 12.5 RG174 cable - SMA 301113 w/ 12.5 RG174 cable - FME 12” Mag Mount w/12.5’ RG58 301103 311125 311128 314202 311703 Trucker Antenna w/10.5’ RG58 311101 311701 10 4G Trucker Antenna w/13.
______ Safety Guidelines Use only the power supply provided in this package. Use of a non-weBoost product may damage your equipment. Connecting the Signal Booster directly to the cell phone with use of an adapter will damage the cell phone. Use only the power supply provided in this package. Use of a non-weBoost product may damage your equipment. The Signal Booster unit is designed for use in an indoor, temperature-controlled environment (less than 150 degrees Fahrenheit).
______ Specifications Drive Sleek Model Number 460035 FCC ID: PWO460035 IC: 4726A-460035 Frequency 698-716 MHz, 729-746 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz Maximum Power Power output for single cell phone (Uplink) dBm 700 MHz Band 12/17 18.74 700 MHz Band 13 21.57 800 MHz Band 5 22.65 1700 MHz Band 4 25.56 1900 MHz Band 2 19.19 Power output for single cell phone (Downlink) dBm 700 MHz Band 12/17 2.1 700 MHz Band 13 2.1 800 MHz Band 5 -2.
______ (SPECIFICATIONS cont.) The term “IC” before the radio certification number only signifies that Industry Canada technical specifications were met. Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only.
2 YEAR WARRANTY weBoost Signal Boosters are warranted for two (2) years against defects in workmanship and/or materials. Warranty cases may be resolved by returning the product directly to the reseller with a dated proof of purchase. Signal Boosters may also be returned directly to the manufacturer at the consumer’s expense, with a dated proof of purchase and a Returned Material Authorization (RMA) number supplied by weBoost. weBoost shall, at its option, either repair or replace the product.
