User's Manual

9
Contact Wilson Electronics Customer Support Team with any questions at
866-839-9361 or email: [e-mail]
Post Install Setup
The Pro Series booster is designed with advanced internal programming which allows
it to automatically adjust itself for a variety of conditions and still boost weak signals.
After completing the amplifier installation, the LCD display and push button on the
lower panel of the Pro Series booster is used to verify the final gain that the booster
adjusted itself to produce after antennas have been placed. The display can also be
used (if necessary) to re-adjust antennas so the booster can produce maximum gain
and therefore, coverage. The LCD screen will show status for each band and inform
the installer if any bands may have had their gain reduced by the booster’s internal
programming. In addition, an indicator light on the booster's upper panel will help
diagnose the overall status of the booster by glowing in different colors. This will be
covered in the following page.
The Pro Plus booster has an integrated graphical meter to simplify the installation
process. This is not to replace your signal meter - rather it complements the use.
The bar graphs will assist in the aiming of your outside antenna - the biggest graph
indicates that you are receiving the best overall signal.
To access this feature for the currently displayed frequency band, press and hold the
"Band Select" button for 2 seconds. This will change the display to the UL/DL bar
graph (uplink/downlink). A quick press of the button will move to the next band (briefly
showing the band, before returning back to the bar graph); while holding the button will
return to the regular display.
UL
DL
press and hold
for 2 seconds
Understanding the LCD Screen
1. Four bands can be individually selected:
The 700 MHz LTE Bands (B12/17 and B13)
OK