ENGLISH FRANÇAIS Home 3G™ Cellular Signal Booster Need help? www.weboost.com Customer Support 866-294-1660 Mon.- Fri.
ENGLISH ! IT IS VERY IMPORTANT TO POWER YOUR SIGNAL BOOSTER USING A SURGE PROTECTED AC POWER STRIP WITH AT LEAST A 1000 JOULE RATING. FAILURE TO DO THIS WILL VOID YOUR WARRANTY IN THE EVENT OF A POWER SURGE OR LIGHTNING STRIKE. ! THE SIGNAL BOOSTER UNIT IS DESIGNED FOR USE IN AN INDOOR, TEMPERATURECONTROLLED ENVIRONMENT (LESS THAN 150 DEGREES FAHRENHEIT). IT IS NOT INTENDED FOR USE IN ATTICS OR SIMILAR LOCATIONS SUBJECT TO TEMPERATURES IN EXCESS OF 150°F.
Package Contents Accessories packaged may not exactly match the below photos due to different kit options Desktop Antenna (301211) Coax Cable (30’ 950630) Cradle Antenna Kit Cradle Antenna 20’ RG6 coax cable (311141-0620) AC Power Supply 6V / 2.5A (Not included with some models) (859912) Included Accessories Cable Connector (971129) Optional Outside Antenna Kit 314473-0640 Kit 991171 Includes Panel Antenna 40’ RG6 cable 1. Pole Mount (Packet A) 2. Wall Mount (Packet B) 3.
ENGLISH Find the Strongest Cellular Signal Before you install your Home 3G signal booster, you must determine the location of the best available cellular signal. This will affect the location of your Outside Antenna and will help you get the best performance from your Home 3G. You can find the strongest signal outside your building, typically at the highest point available, using any of the following methods: 1.
Quick Install - Inside Window Mount Option 4. Insert the Outside Antenna into the cradle. Additional installation options on pg. 6-9 ENGLISH Find the Strongest Cellular Signal (See page 4 for suggested methods.) Ready to Install Inside Window Mount 1. Select a location on the inside of a window as high as possible and at least 20 feet from where the Home 3G will be located.
ENGLISH 8. Connect the Home 3G to a surge protected AC power strip with at least a 1000 Joule rating. If your Home 3G is working correctly, the lights will be green. Installation Options utside Pole Mount O (Best Option) 1. Select a location on the roof where the Outside Antenna can be mounted on a pole maintaining at least 20 feet of vertical or horizontal separation from the inside Desktop Antenna. If the lights are orange or red, see the “Troubleshooting” section on page 9.
5. Connect the supplied coax cable to the antenna lead cable on the Outside Antenna. Rafter Mount 1. Select a location in the building’s rafters where the Outside Antenna can be mounted directly above the Desktop Antenna with at least 20 feet vertical or horizontal separation. The location should allow you to mount the Outside Antenna roughly in the direction of the strongest cellular signal. ENGLISH 6. Route the cable as desired to the location of the Home 3G.
ENGLISH If possible, place the Desktop Signal Antenna directly beneath the placement of the Outside Antenna location. This creates a maximized signal zone within the room where the Desktop Antenna remains. Place the desktop signal antenna directly beneath the placement of the Outside Antenna location At least 20 feet of vertical or horizontal separation from the desktop antenna is needed 5.
has shut off on the associated frequencies to prevent oscillation (feedback). 3. Attach the Inside Antenna to the connector labeled “Inside Antenna.” 4. Ensure the Inside Antenna is facing away from both the Home 3G and the Outside Antenna. Note Face Inside Antenna away from Home 3G and Outside Antenna Green/Orange Blinking indicates that the booster is operating at a reduced gain due to close proximity of a cell tower.
ENGLISH Move the outside antenna away from the strongest cellular signal in small increments 2. If the light remains orange, or if the green/orange blinking light indicating reduced gain is not providing enough coverage area, contact the weBoost Customer Support Team for assistance: 866-294-1660. Lights Off Inside area needing increased signal If one or more of the lights on the Signal Booster are off verify power to your surge protected power strip.
50 Ohm Outside Antenna Kits Kit 314453-5825 • 50 Ohm Pole Mount Panel Antenna • 25’ RG58 Cable Kit 314411-5825 • 50 Ohm Wide Band Directional • 25’ RG58 Cable Kit 301111-5850 • Yagi Directional Antenna • 50’ RG58 Cable Kit 311129-5840 • 8000 MHz Yagi Directional • 40’ RG58 Cable Kit 311203-5820 • Omni-Directional antenna • 20’ RG58 Cable Kit 311124-5830 • 1900 MHz Yagi Antenna • 30’ RG58 Cable Kit 311203-40020 • Omni-Directional antenna • 20’ LMR400 Cable Kit 301111-400170 • Yagi Directional w/ N-Female • 1
Safety Guidelines ENGLISH WARNING: To uphold compliance with network protection standards, all active cellular devices must maintain at least 6 feet of separation distance from Panel and Dome antennas and 4 feet of separation distance from Desktop antennas. WARNING: C onnecting the Signal Booster directly to the cell phone with use of an adapter will damage the cell phone. WARNING: Use only the power supply provided in this package. Use of a non-weBoost product may damage your equipment.
Signal Booster Specifications Home 3G™ Model Number 460026 Connectors F-Female / SMA-Female ENGLISH Antenna Impedance (inside / outside) 50 Ohms / 75 Ohms Frequency 824-894 MHz, 1850-1995 MHz Passband Gain (nominal) 800 MHz, Band 5 60.2 1900 MHz, Band 2 63.5 20 dB BandwiHome 3Gh (MHz) 800 MHz, Band 5 1900 MHz, Band 2 37.3 38.8 79.1 81.9 Typical Maximum Power output for single cell phone (dBm) 800 MHz, Band 5 Uplink Downlink 1900 MHz, Band 2 24.7 12.26 24.8 9.
ENGLISH 2-Year Warranty weBoost Signal Boosters are warranted for two (2) years against defects in workmanship and/or materials. Warranty cases may be resolved by returning the product directly to the reseller with a dated proof of purchase. Signal Boosters may also be returned directly to the manufacturer at the consumer’s expense, with a dated proof of purchase and a Returned Material Authorization (RMA) number supplied by weboost. weBoost shall, at its option, either repair or replace the product.
