® SIGNAL Signal 4G Need help? www.WilsonElectronics.com Tech Support 866-294-1660 Mon.- Fri.
! IT IS VERY IMPORTANT TO POWER YOUR SIGNAL BOOSTER USING A SURGE PROTECTED AC POWER STRIP WITH AT LEAST A 1000 JOULE RATING. FAILURE TO DO THIS WILL VOID YOUR WARRANTY IN THE EVENT OF A POWER SURGE OR LIGHTNING STRIKE. ! THE SIGNAL BOOSTER UNIT IS DESIGNED FOR USE IN AN INDOOR, TEMPERATURECONTROLLED ENVIRONMENT (LESS THAN 150 DEGREES FAHRENHEIT). IT IS NOT INTENDED FOR USE IN ATTICS OR SIMILAR LOCATIONS SUBJECT TO TEMPERATURES IN EXCESS OF 150°F.
2. Select a location to install the Signal Booster that is away from excessive heat, direct sunlight, moisture and that has proper ventilation. Do not place the Signal Booster in an air-tight enclosure. 3. Run the Outside Antenna cable to the Signal Booster and attach it to the connector labeled “Outside Antenna.” 4. An external adapter may be needed to connect the cellular device to the Signal Booster.
Warnings and Recommendations Mobile Antennas WARNING: Verify that both the Outside Antenna and the adapter extension cable are connected to the Signal Booster before powering up the Signal Booster. WARNING: Use only the power supply provided in this package. Use of a non-Wilson Electronics products may damage your equipment. WARNING: The Outside Antenna must be installed no higher than 10 meters (31’9”) above ground.
Signal Booster Specifications Signal 4G Model Number 460025 Connectors SMA Antenna Impedance 50 Ohms Frequency 698-716 MHz, 746-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz Passband Gain (typical) 20 dB Bandwidth (MHz) Maximum 700MHz Band12/17 11.0 700MHz Band13 10.0 800MHz 10.0 1700/2100MHz 10.0 1900MHz 10.0 700MHz Band12/17 700MHz Band13 800MHz 1700/2100MHz 1900MHz 36.3 36.4 44.7 94.3 85.
