User's Manual

5
Need help? www.WilsonElectronics.com
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
Installation Options
In-Building Installation Option
1. Install the antenna to a window. These
instructions are for use with the Wilson
Electronics Magnet-Mount or Mini-Magnet
Mount Antenna. If you purchased a different
antenna separately, follow the instructions
included with that antenna.
• Select a window on the side of the building
where you get the strongest cell signal. You
can determine the strongest signal area by
walking around the building and checking
the bars on your mobile phone. You should
wait 30 seconds for new signal strength
to register. For a more accurate method
of determining signal strength, read the
instructions at http://www.wilsonelectronics.
com/test-mode-instructions.
WAIT 30
SECONDS
• Clean a spot as high on the designated
window as possible with the alcohol prep pad.
Attach the suction cup bracket to the cleaned spot
on the inside of the window.
NOTE: Many newer energy efcient windows use
a metal coating that may decrease the strength
of a cellular signal, reducing the effectiveness of
the MobilePro. If you have dual pane windows,
consider a Wilson Electronics signal boost product
that provides an option for mounting an antenna on
an outside wall or roof of a building.
• With the bracket in place, attach the
magnet base of the antenna to the at
surface of the bracket. The antenna must
be mounted vertically for the best signal.
2. Attach the antenna to the MobilePro
signal booster. Connect the cable from the
antenna to the connector on the bottom
of the signal booster. Do NOT plug in the
power supply (step 4) until the antenna
cable is connected to the MobilePro signal
booster.
3. Place the MobilePro signal booster in a
convenient location close to your cellular
device. This can be on a desk, a tabletop,
a shelf, or the optional desktop mount (sold
separately). The MobilePro works best when
within three feet of your mobile device.
WORKS BEST
WHEN WITHIN
3 FEET
4. Connect the MobilePro to a power supply.
Attach the AC power cord to the mini-USB
port on the bottom of the signal booster.
Plug the AC power cord into a surge
protected power strip.