User's Manual

Need help? www.WilsonElectronics.com Tech Support 866-294-1660

Mon.- Fri. Hours: 7 am to 6 pm MST

BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider

and have your provider’s consent. Most wireless providers consent to the use of

signal boosters. Some providers may not consent to the use of this device on their

network. If you are unsure, contact your provider.

You MUST operate this device with approved antennas and cables as specified by

the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any

person.

You MUST cease operating this device immediately if requested by the FCC or a

licensed wireless service provider.

WARNING. E911 location information may not be provided or may be inaccurate

for calls served by using this device.

This is a CONSUMER device.

Safety Guidelines

Warning: In a wireless installation, do not plug the Signal Booster directly into the cell phone or cellular data card

using an antenna adapter. It will damage the Signal Booster, cell phone or cellular data card.

Warning: Do not plug in the DC power supply until the Outside and Inside Antenna cables are attached to the

Signal Booster.

Warning: Warning: The Inside Mobile Antennas must have 1.5 feet of separation distance from all users and the

Inside Fixed Antennas must have 6 feet of separation distance from all users.

Warning: RF Safety: Any antenna used with this device must be located at least 8 inches from all persons.

Warning: Use only the power supply provided in this package. The power supply must be 12 V DC Output.

This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation. Changes or modifications not expressly approved by Wilson Electronics could void the authority to

operate this equipment.

Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be

adjusted without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming

and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster is not in use

for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the

Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on that band. For a detected

oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such

automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted

by momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal

Booster’s microprocessor.