User's Manual

4
Need help? www.WilsonElectronics.com
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
 •Withthebracketinplace,attachthe
magnetbaseoftheantennatotheat
surface of the bracket. The antenna must
be mounted vertically for the best signal.
2. Install the Mounting Bracket and Sleek 4G.
Put your Sleek 4G in the Mounting Bracket
(see instructions under Vehicle Installation)
and place it in a convenient location such as
a desk or table top in the room where you will
use the phone. The location should be at least
three feet from the Outside Antenna to avoid
oscillation (feedback). Your cell phone must
be in the cradle for the Sleek 4G to amplify the
signal. Use a Bluetooth headset, wired hands-
free device or speakerphone for talking on the
phone.
3. Attach the antenna to the Sleek 4G.
Connect the cable from the Outside Antenna
to the antenna connector on the bottom of
the Sleek 4G. Do NOT plug in the power
supply (next step) until the Outside Antenna
cable is connected to the Sleek 4G.
4. Power up your Sleek. Connect the power
cable to the mini-USB port on the bottom of
the Sleek. Then insert the adapter into the
AC power supply (859969), sold separately.
Use only the supplied Wilson Electronics
power supply.
6. Power up your Sleek 4G. Connect the
power cable to the mini-USB port on the
bottom of the Sleek 4G. Then insert the
adapter into the vehicle 12V DC power
source. Use only the supplied Wilson
Electronics power supply. While the Sleek
4G may remain on, leaving the Sleek 4G
on in a vehicle when it is not running may
discharge the battery in a day or two. Also
note that some 12V DC power sources
are shut down when the vehicle ignition is
turned to off. Use a Bluetooth headset, wired
hands-free device or speakerphone for talking
on the phone.
Option 2: In-Building Installation
Note: Home Ofce Accessory Kit sold separately
1. Install the Outside Antenna to a window. For
best results:
 •Selectawindowonthesideofthe
building where you get the strongest cell
signal.
 •Attachthesuctioncupbracket(sold
separately) to the inside of a window so
the cable will reach the location of the
Mounting Bracket and Sleek 4G. Place
the bracket as high on the window as
possible.
 NOTE:Manynewerenergyefcientdual
pane windows use a metal coating that may
decrease the strength of a cellular signal,
reducing the effectiveness of the Sleek 4G.
If you have dual pane windows, consider a
Wilson Electronics signal boost product that
provides an option for mounting an antenna on
an outside wall or roof of a building.