User's Manual

3
Need help? www.WilsonElectronics.com
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
Installation Options
Option 1: Vehicle Installation
1. Attach the Mounting Bracket to the vehicle’s
dashboard.
 •Cleantheareawherethebracketistobe
mounted with the alcohol wipe included.
Allow the area to dry.
 •Peelthebackingtoexposetheadhesive
and press the bracket onto the desired
location on the dashboard. NOTE: Be
sure the tab is positioned vertically.
 •Allowtheadhesivetocurefor24hours
before you attach the Sleek 4G (Step
4).
2. Install the Outside Antenna. Select a
location on top of the car that is:
 •Nearthecenterofthevehicle’sroof.
 •Atleast12inchesfromanyother
antennas.
 •Freeofobstructions.
 •Atleast6inchesfromanywindows
(including sunroofs).
 •Atleast8inchesfromanypeople.
The Outside Antenna must be installed
vertically.
3. Run the Outside Antenna cable into the car.
The cable is strong enough that it may be
shut in most vehicle doors without damaging
the cable. For a cleaner look, carefully pull
down the door seal, run the cable under the
seal, and push the seal back into place. This
method reduces wear on the cable as the
door opens and closes.
4. Attach the Sleek 4G to the Mounting
Bracket. After waiting 24 hours for the
adhesive on the bracket to cure, attach the
Sleek 4G by aligning the rectangular hole
on the back of the Sleek 4G with the tab on
the Mounting Bracket, grasping the sides
of the Sleek 4G, and sliding it downward
approximately ¼ inch into place.
The Mounting Bracket is designed to swivel
for more convenient viewing angles. Once
the Sleek 4G is in place, you can adjust
the angle of the bracket by loosening the
knurled nut, applying gentle pressure to the
top or bottom of the Sleek 4G, and then
tightening the nut when the desired angle is
achieved.
5. Attach the antenna to the Sleek 4G.
Connect the cable from the Outside Antenna
to the antenna connector on the bottom of
the Sleek 4G. Do NOT plug in the power
supply (next step) until the Outside Antenna
cable is connected to the Sleek 4G.
Note: The Sleek 4G has a convenient USB
charging port located on the right side
of your booster. This port allows for
charging your phone or device, using
your existing cable.