User Manual

5
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
In-Building Installation
Installing a Wilson Electronics Outside Antenna in a Building
Follow the specic antenna instructions included with the Outside Antenna. These instructions assume
that you are using a Wilson Electronics Mini-Magnet Mount Antenna and the optional suction cup window
bracket.
To receive the best signal, select a window on the side of your building where your outside signal is the
strongest.
Attach the suction cup bracket to the inside of a window so that the cable will reach
the location of the Sleek. Place the bracket as high on the window as possible for
best performance.
Once the bracket is in place, attach the magnet base of the antenna to the at
surface of the bracket. Note: The antenna must be installed vertically. Signal
performance will be degraded if the antenna is not vertical.
Installing the Wilson Electronics Sleek
®
Signal Booster in a Building
The Wilson Electronics Sleek may be placed in any convenient indoor location, such as a desk or
tabletop. The cell phone or data card must be in the cradle and use a Bluetooth
™
headset or wired
hands free device for voice communications.
Attaching the Antenna
Once you have selected the location for the Sleek, run the cable from the outside antenna and attach it
to the SMA connector on the bottom of the Sleek.
Note: The cell phone must be placed in the Sleek cradle to amplify properly.
Warning: The Sleek
®
and the Outside Antenna must have a minimum separation of 3 feet to
prevent oscillation.
Outside Antenna
communicates
with cell tower
Sleek amplies signal
to & from cell tower
Sleek powered through surge
protected AC Power Strip
IMPORTANT NOTICE
• It is very important to power your Signal Booster using a surge protected AC Power Strip
with at least a 1000 Joule rating.
• Failure to do this will void your warranty in the event of a power surge or lightning strike.
Troubleshooting
SYMPTOM: No increase in bars
1. Make sure that the antenna connector is tight.
2. The cell phone must be placed in the Sleek cradle to amplify properly.
3. Call Wilson Electronics Technical Support at 866-294-1660.
Warning: DO NOT use phone covers that have chrome or any other metallic surface. It may
block cellular signals