User's Manual

9
10
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
Powering up a Wilson Electronics Signal Booster
1. Never point the front of a Directional Outside Antenna toward the Inside
Antenna. Refer to Figures 1 & 2 below.
2. Ensure that both the Outside Antenna cable and the Inside Antenna cable are
connected to the splitter and the Signal Booster and the connections are tight
before powering up the Signal Booster.
3. Plug the power supply into the Signal Booster input marked “POWER” (carefully,
to avoid damaging the center pin) and then into a Surge Protector Power Strip.
4. If the Signal Booster does not have green lights, please refer to pages 11 & 12.
5. If you are not using a band, reduce the gain all the way down to minimum until
the light turns off. This will reduce the power consumption of the Signal Booster.
6. Using multiple Signal Boosters in one installation could cause interference to the
cell tower.
7. Contact Wilson Electronics Technical Support Team with any questions at
866-294-1660 or email [e-mail]. Technical Support hours
are Mon.- Fri. 7 am to 6 pm MST.
Figure 1
Figure 2
Signal Booster
Outdoor
Antenna
Outdoor
Antenna
Inside Panel
Antenna
CORRECT INSTALLATION
Point antennas away from each other
INCORRECT INSTALLATION
Never point antennas toward each other
Inside Panel
Antenna
Signal Booster