User's Manual

5 6
Contact Wilson Electronics’s Technical Support Team with any questions at 866-294-1660
Or email: [e-mail] Mon.- Fri. Hours: 7am to 6 pm MST.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or modications not expressly
approved by Wilson Electronics could void the authority to operate this equipment.
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal
Booster cannot be adjusted without factory reprogramming or disabling the hardware. The Signal
Booster will amplify, but not alter the incoming and outgoing signals in order to increase coverage of
authorized frequency bands only. If the Signal Booster is not in use for ve minutes, it will reduce gain
until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster
detects and oscillation, the Signal Booster will automatically turn the power off on that band. For a
detected oscillation the Signal Booster will automatically resume normal operation after a minimum of
1 minute. After 5 (ve) such restarts, any problematic bands are permanently shut off until the Signal
Booster has been manually restarted by momentarily removing the power from the Signal Booster.
Noise power, gain, and linearity are maintained by the Signal Booster’s microprocessor.
Warnings and Recommendations
Warning: In a wireless installation, do not plug the Signal Booster directly into the cell phone or
cellular data card using an antenna adapter. It will damage the Signal Booster, cell
phone or cellular data card.
Warning: Do not plug in the DC power supply until the Outside and Inside Antenna cables are
attached to the Signal Booster.
Warning: The Inside Antennas must have a 1.5 feet of separation distance from all active users.
Warning: RF Safety: Any antenna used with this device must be located at least 8 inches from
all persons.
Warning: Use only the power supply provided in this package. The power supply must be 6 V DC
Output.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your
provider’s consent. Most wireless providers consent to the use of signal boosters. Some
providers may not consent to the use of this device on their network. If you are unsure, contact
your provider.
You MUST operate this device with approved antennas and cables as specified by the
manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person.
You MUST cease operating this device immediately if requested by the FCC or a licensed
wireless service provider.
WARNING. E911 location information may not be provided or may be inaccurate for calls served
by using this device
.
This is a CONSUMER device.