I Installation Guide '\ Drive RV Antenna
Index Package Contents ............................................................ 1 Select Mounting Location .................................................... 2 Assemble the Antenna ........................................................3 Mounting the Antenna ....................................................... 5 Safety Guidelines & Specifications ............................................ 6 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Package Contents I I I Drive RV Antenna w/25 ft. Cable (311230) 13 in.
Select Mounting Location common outside antenna location ~~~ Mount Outside Antenna to a ladder or pole, so that the entire Outside Antenna is above the roof line of the RV and clear of other metal obstructions. We recommend doing a 'soft install', verifying the system works as desired, before permanently installing the kit. ~ / D ...... NOTE: Keep in mind to stay below the maximum height limit allowed by law, which varies from state to state (generally 14 ft. in western states and 13 ft.6 in.
Assemble the Antenna Once you have determined the best location for the antenna, insert cable through mast(s) then through Side Exit Adpater. ' • •• i 13 in. 13 in.
(Assemble the Antenna cont.) Drive OTR Antenna Use thread locker (provided) to thread points and screw into place. NOTE: Be sure the antenna is the correct height before applying thread locker. NOTE: When adding the side exit adapter hold the antenna vertically and screw the adapter from the bottom up. This reduces cable twisting.
Mounting the Antenna Mount to ladder rail on RV as shown and route cable into RV then connect cable to the booster. The system performs best with maximum vertical and horizontal separation. Side Exit Adapter t ~=>--"" NOTE: If installing with Spring, the Side Exit Adapter must be used.
\ Safety Guidelines & Specifications RF Safety Warning: Any antenna used with this device must be located at least 8 inches from all persons. AWS Warning: The Outside Antenna must be installed no higher than 32 feet 9 inches (10 meters) above ground. Electrical Specifications ,,. 698-80p Frequency Band (MHz) 2300-2700 1710-1880 ,'3.8 ,, Peak Gain (dBi) Gain (dBi), Typical @ 2° Elevation Cable loss LMR-195 30 in. VSWR Efficiency (%) ~<"- .,, t',;; · .. ------------------------(i Polarization : .
0 2 YEAR WARRANTY Antennas may also be returned directly to the manufacturer at the consumer's expense, with a dated proof of purchase and a Returned Material Authorization (RMA) number supplied by Wilson Electronics. Wilson Electronics shall, at its option, either repair or replace the product. Wilson Electronics will pay for delivery of the repaired or replaced product back to the original consumer if located within the continental U.S.
' f You(D 3301 East Deseret Drive, St. George, UT 6J, 866.294.1660 Cl) www.wilsonelectronics.com C2'.I support@wilsonelectronics.com Copyright © 2020 Wilson Electronics. All rights reserved. Wilson Electronics products covered by U.S. patent(s) and pending application(s) For patents go to: weboost.com/us/patents NOT AFFILIATED WITH WILSON ANTENNA GDE000300_Rev01_08.10.
Drive RV Antenna SKU: 311230 MAP: $99.99 FEATURES • Covers 700, 800, 1700, 1900, 2200 MHz cellular • All modes, voice and data • High gain signal output • Antenna can be configured into multiple lengths from 7.5 - 20.5 in.
X Radiation Patterns, 700-900 MHz 700 MHz 800 MHz 900 MHz Radia�on Pa�erns 2D Radia�on Pa�erns E Plane Test Setup Y Z H Plane Z Y X X Radiation Patterns, 1700-2100 MHz 1700 MHz 1900 MHz 2100 MHz _________________________________________________________________________________________ ________________________________________________________________________________________ E Plane X Z H Plane Y X
Radiation Patterns, 2300-2700 MHz 2300 MHz 2500 MHz 2700 MHz H Plane E Plane Z X Y X to include cable losses. Note: Gain values at 2° eleva�on indicated are without cable loss. Please refer to the electrical specs chart Note: Gain values at 2° elevation indicated are without cable loss. Please refer to the electrical specs chart to include cable losses. Peak Gain (@ 2° Eleva�on) nNote: values at 2° eleva�on without loss.
____________________________________________________________________________________________________ Efficiency (%) Efficiency (%) Note: cable loss. Please toto the electrical specs chart to to include cable losses. Note:Gain Gainvalues valuesatat2°2°elevation eleva�onindicated indicatedare arewithout without cable loss. Pleaserefer refer the electrical specs chart include cable losses. Package Dimensions Support 8.14 W x 15.97 L x 3.66 D 8.14 in. x 15.97 in. FRONT 3.66 in. x 15.97 in. SIDE 8.
