User's Manual

Signal Booster Specications
Sleek 4G-A
Model Number 2B5325
Connectors SMA
Impedance (input/output) 50 ohms
Frequency 698-746 MHz / 824-894 MHz / 1850-1990 MHz
1
Passband Gain (nominal)
Uplink
Typical / Maximum
Downlink
Typical / Maximum
800 MHz 20 dB / 22 dB 17 dB / 19 dB
1900 MHz 17 dB / 19 dB 18 dB / 20 dB
2
20 dB Bandwidth (nominal)
Uplink
Typical / Maximum
Downlink
Typical / Maximum
700 MHz N/A N/A
800 MHz 25 MHz / 28 MHz 25 MHz / 28 MHz
1900 MHz 61 MHz / 67 MHz 61 MHz / 67 MHz
Power output for single cell phone
(uplink) dBm
700 MHz 800 MHz 1900 MHz
CDMA N/A 28.2 26.8
GSM N/A 27.8 26.4
EDGE N/A 26.8 26.3
WCDMA N/A 26.8 25.3
LTE 27.5 26.8 25.8
Power output for single cell phone (dowlink)
dBm
700 MHz 800 MHz 1900 MHz
CDMA N/A -4.8 -3.8
GSM N/A -6.6 -5.2
EDGE N/A -6.5 -5.3
WCDMA N/A -6.7 -3.9
LTE -5.3 -5.5 -4.3
3,4
Power output for multiple
received channels (uplink) dBm
The maximum power is reduced by
the number of channels:
Number of
channels
Maximum Power
3
800 MHz 1900 MHz
2 24.0 20.1
3 20.5 16.6
4 18.0 14.1
5 16.1 12.2
6 14.5 10.6
3,4
Power output for multiple
received channels (downlink) dBm
The maximum power is reduced by
the number of channels:
Number of
channels
Maximum Power
3
800 MHz 1900 MHz
2 -6.1 -7.8
3 -9.6 -11.3
4 -12.1 -13.8
5 -14.0 -15.7
6 -15.6 -17.3
Noise Figure (typical) 3 dB nominal
Isolation > 40 dB
Power Requirements 5V DC, 1A
Notes:
1. Nominal gain is the maximum gain at any frequency in the passband.
2. Nominal bandwidth is the difference between two frequencies that are adjacent to the passband where the amplication is 20 dB lower than the passband amplication. One
of the frequencies is lower than the passband and the other is higher.
3. The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the rating would have to be
reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users. This power reduction is to be by means of input
power or gain reduction and not by an attenuator at the output of the device.
4. The maximum power for 2 or more simultaneous signals will be reduced by 6 dB every time the number of signals is doubled.
3301 East Deseret Drive, St. George, UT 84790
For additional Technical Support visit www.WilsonElectronics.com
or email at: [e-mail]
Phone: [phone] Local: 435-673-5021 Fax: [phone]
www.twitter.com/WilsonCellular www.facebook.com/WilsonCellular
U.S. Patent Nos. –
Copyright © 2012 Wilson Electronics, Inc. All rights reserved.