User's Manual

3
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
4
2. Attach the Mounting Bracket
A mounting bracket is provided for attaching the Sleek to your vehicle’s dash. Other options are also
available from Wilson Electronics.
3. Attach the Sleek
®
to the Bracket
Once you have installed the bracket in the desired location, and waited 24 hours for adhe-
sive to cure, attach the Sleek by aligning the rectangular hole on its back with the tab on
the mount bracket, grasping the sides of the Sleek, and sliding it downward approximately
¼ inch into place.
Once the cradle is attached, you can adjust the angle of the adhesive bracket by applying
gentle pressure to the top or bottom of the Sleek. The bracket is designed to swivel when
the knurled nut is loosened for greater adjustability of the Sleek viewing angle. To lock
bracket into position, tighten large nut.
ADHESIVE BRACKET- Included in this package
1. Clean the area where the bracket is to be mounted with the
supplied alcohol wipe. Allow to dry.
2. Peel the backing to expose the adhesive and press the
bracket onto the desired location in the vehicle. Note: Be sure
the tab is positioned vertically, not horizontally.
3. Allow the adhesive to cure for 24 hours before you attach
the Sleek.
Power up the Wilson Electronics Sleek
®
Accessory port to power your phone, some adapters available
through Wilson Electronics at 866-294-1660. (See Figure 2)
Connect the mini-USB plug on the power cable to the Sleek’s mini
USB port located on the bottom of the Sleek and insert the adapter
into the vehicle power adapter of your vehicle. The Sleek may remain
on all the time. However, leaving the Sleek on in a vehicle when it is
not running can discharge the battery in a day or two.
Note: The 12V DC power source on many vehicles is shut off
with the ignition key.
Warning: Use only the supplied Wilson Electronics power
supply.
Warning: Make sure the Outside Antenna cable is
connected before powering up the Sleek.
4. Attach the Outside Antenna cable to the Sleek
®
Attach the cable from the Outside Antenna to the antenna connector
on the Sleek. (See Figure 1)
Accessory USB Power port
Figure 2
Sleek Power port. Connect the
Wilson Electronics’s power supply
Antenna
connection
Figure 1