User's Manual

5
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
6
In-Building Installation
Installing a Wilson Electronics Outside Antenna in a Building
Follow the specic antenna instructions included with the Outside Antenna (sold separately except for
certain kits). These instructions assume that you are using a Wilson Electronics Mini-Magnet Mount
Antenna and the optional suction cup window bracket.
Attach the suction cup bracket to the inside of a window so that the cable
will reach the location of the Sleek 4G. Place the bracket as high on the
window as possible for best performance.
Once the bracket is in place, attach the magnet base of the antenna to the
at surface of the bracket. Note: The antenna must be installed vertically.
Signal performance will be degraded if the antenna is not vertical.
Installing the Wilson Electronics Sleek 4G
®
Signal Booster in a Building
The Wilson Electronics Sleek 4G may be placed in any convenient indoor location, such as a desk or
tabletop. The cell phone or data card must be in the cradle and use a Bluetooth
®
headset or wired hands
free device for voice communications.
Attaching the Antenna
Once you have selected the location for the Sleek 4G, run the cable from the Outside Antenna and
attach it to the connector on the bottom of the Sleek.
NOTE: The Sleek 4G and the Outside Antenna
must have a minimum separation of 3
feet to prevent oscillation.
Outside Antenna
communicates with
cell tower
Sleek 4G boosts signal to
& from cell tower
Sleek 4G powered through surge
protected AC Power Strip
IMPORTANT NOTICE
It is very important to power your Signal Booster using a surge protected AC Power Strip •
with at least a 1000 Joule rating.
Failure to do this will void your warranty in the • event of a power surge or lightning strike.
Troubleshooting
SYMPTOM: No increase in bars
1. Make sure that the antenna connector is tight.
2. The cell phone must be placed in the Sleek 4G cradle to amplify properly.
3. Call Wilson Electronics Technical Support at 866-294-1660.
NOTE: The cell phone must be placed in
the Sleek cradle to amplify properly.
To receive the best signal, select a window on the side of your building
where your outside signal is the strongest.