User's Manual

5
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail] Hours: 7 am to 6 pm MST.
6
Warnings and Recommendations
Warning: Verify that both the outside antenna and the adapter extension cable are
connected to the signal booster before powering up the signal booster.
Warning: Use only the power supply provided in this package. Use of a non-WIlson
Electronics products may damage your equipment.
Warning: RF Safety: All omni-directional antennas shown on page 1 must be
installed so that the distance from the antenna to any person is no less
than 8 inches. All Yagi antennas shown on page 1 must be installed
so that the distance from the antenna to any person is no less than 26
inches. Yagi antennas may not be used indoors or in a mobile installation.
Please contact Wilson Electronics Technical Support Team for safe
distances from other antennas.
Lightning protection is recommended for all in-building installations.
It is recommended to verify that outside antenna installations comply with relevant electrical
codes (e.g. National Electrical Code).
NOTE: The aluminum casing of a Wilson Electronics signal booster will adjust very quickly
to the ambient temperature of its environment. For example, in the summer, when the
inside of a car can reach 140 degrees Fahrenheit, the signal booster temperature may be
150 degrees or higher. The casing will be hot to the touch, similar to a metal door handle or
a steering wheel. Such high temperatures will not damage the signal booster, nor do they
pose a fire risk to the structure. As recommended in these instructions, install the signal
booster in a location with adequate ventilation. Keep the area free of items that could block
air flow to the signal booster. Do not install the signal booster in direct sunlight.
Mobile Installation
In-Building Installation
Outside
Antenna
Outside
Antenna
(Point towards
cell tower)
Signal Booster
Signal
Booster
DC Power Supply
Power
Supply
Connect to
cell phone or
data card
Connect to
cell phone or
data card
This is the recommended install for in-vehicle
use. Contact our Technical Support Team for
more information at: 866-294-1660 or tech@
wilsonelectronics.com
This is the recommended install for in-building
use. Contact our Technical Support Team for
more information at: 866-294-1660 or tech@
wilsonelectronics.com
AC Surge
Protector
Lightning
Surge
Protector