User's Manual

3
4
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail] Hours: 7 am to 6 pm MST.
Powering up a Wilson Electronics Signal Booster
Ensure that both the outside antenna coax cable and the adapter coax cable are con-1.
nected to the signal booster before powering up the signal booster.
Connect the power supply to the power input labeled with the USB symbol on the 2.
signal booster. Plug the power supply into a wall outlet.
The indicator light on the top of the signal booster will be GREEN when the unit is pow-3.
ered up and working properly.
If the light is off, ensure power supply connections are tight.4.
Carefully insert the
power cable.
Warning: Use only a Wilson Electronics
power supply. Use of a non-Wilson
Electronics product could damage your
equipment.
!
Warning: Verify that both the outside
antenna and the adapter extension cable
are connected to the signal booster before
powering up the signal booster.
!
Testing a Wilson Electronics Signal Booster
To test your signal booster, go to a weak signal area where your cell phone registers only
1-2 bars without the signal booster turned on. Then, connect the signal booster to the
phone and you should see a signal improvement of 2 or more bars. Note: Many phones
take up to 30 seconds to reset the bar indicator.
Installing the Mounting Plate on DataPro™ Signal Booster (optional)
To purchase a mounting plate call Wilson Electronics Sales Team 800-204-4104.
Remove two screws from back of
signal booster that correspond with the
mounting plate.
Place signal booster on mounting plate
and reinstall the two screws previously
removed from back of signal booster.
Caution: Do not remove “Void Sticker.”