User's Manual

11
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
12
The Uplink (UL)/Downlink 1.
(DL) gain is displayed on LCD
screen above the knobs. Turn
knob to adjust. Refer to page
13 for Overload information.
The yellow CH Select 2.
(Channel) button will select the
channel.
The Uplink (UL) knob limits only 3.
the uplink gain, whereas the
Downlink (DL) knob limits both
the uplink and the downlink
gain. For common settings refer
to chart on page 15.
You will typically adjust only the 4.
downlink knob.
If the Signal Booster is operating normally the LCD Screen will 5.
appear as shown in Figure 3.
LCD, Uplink & Downlink Directions for 800 MHz
(#807180)
CH
Select
UL CH DL
70 A 72
800 MHz Channelized
Max
Min
UL
Gain
Max
Min
DL
Gain
Channel
Uplink Gain (dB)
Downlink Gain (dB)
If you do not know your channel setting: 2.
Option 1: Watch the signal strength on your phone inside the building.
(To put your phone in test mode visit www.WilsonElectronics.com or
contact Wilson Electronics Technical Support Team at 866-294-1660.)
This allows you to read the signal strength from the cell tower. Press
the yellow “CH Select” button until you have the best signal. Refer to
page 5 & 6 on how to read the signal strength from the cell tower.
Option 2: You may also contact your wireless service provider for
optimal channel setting information.
Push the yellow “CH Select” button to change the Uplink Center, 1.
Frequency and Bandwidth.
Pass Bandwidth is the center bottom number. It changes between 5 2.
and 15 MHz each time you press the “Ch Select” button.
Uplink center frequency is the top number on the screen. It 3.
steps 2.5 MHz every other time you push the “CH Select” button.
LCD, Uplink & Downlink Directions for 1900 MHz
(#807380)
Figure 3