User's Manual

7
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
8
Powering up a Wilson Electronics In-Line
Signal Booster
1. Never point the front of a Directional Outside Antenna toward the
Inside Antenna. See Figures 1 & 2 on page 8.
2. Run the antenna cable from the In-Building “Inside Antenna” connector
to the In-Line Signal Booster “Outside Antenna” connector and attach
to both connectors. Run the Inside Antenna cable to the In-Line Signal
Booster and attach it to the connector labeled “Inside Antenna” on the
In-Line Signal Booster. For more information on running cable (see page
3 & 4).
3. Plug the 6-volt power supply into the Signal Booster input marked “6V
DC” (carefully, to avoid damaging the center pin) and then into a surge
protected AC Power Strip with at least a 1000 Joule rating.
4. If the Signal Booster does not have a green light(s), please see pages
9 & 10.
5. If you know that only one frequency band (800 or 1900) is available in
your coverage area (or going to be used), reduce the gain control on
the frequency band that is NOT in use to the lowest setting. This will
reduce the power consumption of the Signal Booster.
6. Using multiple Signal Boosters other than the In-Line in one
installation could cause interference to the cell tower.
7. Contact Wilson Electronics Technical Support Team with any questions
at 866-294-1660 or email [e-mail]. Technical
Support hours are Mon.- Fri. 7 am to 6 pm MST.